Bringing Back the Dead

Wow, it has been a while, hasn't it. Maybe I should call it the tip of the month. Or at least set my sights a little lower, say on the tip of the week.

In any case. Death is inevitable, even for D&D characters. Several spells have the power to restore slain characters to life.

When a living creature dies, its soul departs its body, leaves the Material Plane, travels through the Astral Plane, and goes to abide on the plane where the creature’s deity resides. If the creature did not worship a deity, its soul departs to the plane corresponding to its alignment. Bringing someone back from the dead means retrieving his or her soul and returning it to his or her body.

Any creature brought back to life usually loses one level of experience. The character’s new XP total is midway between the minimum needed for his or her new (reduced) level and the minimum needed for the next one. If the character was 1st level at the time of death, he or she loses 2 points of Constitution instead of losing a level.

This level loss or Constitution loss cannot be repaired by any mortal means, even wish or miracle. A revived character can regain a lost level by earning XP through further adventuring. A revived character who was 1st level at the time of death can regain lost points of Constitution by improving his or her Constitution score when he or she attains a level that allows an ability score increase.
Preventing Revivification

Enemies can take steps to make it more difficult for a character to be returned from the dead. Keeping the body prevents others from using raise dead or resurrection to restore the slain character to life. Casting trap the soul prevents any sort of revivification unless the soul is first released.
Revivification against One’s Will

A soul cannot be returned to life if it does not wish to be. A soul knows the name, alignment, and patron deity (if any) of the character attempting to revive it and may refuse to return on that basis.

Vision And Light

Dwarves and half-orcs have darkvision, but everyone else needs light to see by.

In an area of bright light, all characters can see clearly. A creature can’t hide in an area of bright light unless it is invisible or has cover.

In an area of shadowy illumination, a character can see dimly. Creatures within this area have concealment relative to that character. A creature in an area of shadowy illumination can make a Hide check to conceal itself.

In areas of darkness, creatures without darkvision are effectively blinded. In addition to the obvious effects, a blinded creature has a 50% miss chance in combat (all opponents have total concealment), loses any Dexterity bonus to AC, takes a -2 penalty to AC, moves at half speed, and takes a -4 penalty on Search checks and most Strength and Dexterity-based skill checks.

Characters with low-light vision (elves, gnomes, and half-elves) can see objects twice as far away as the given radius. Double the effective radius of bright light and of shadowy illumination for such characters.

Characters with darkvision (dwarves and half-orcs) can see lit areas normally as well as dark areas within 60 feet. A creature can’t hide within 60 feet of a character with darkvision unless it is invisible or has cover.

Dragonhide Armor

Armorsmiths can work with the hides of dragons to produce armor or shields of masterwork quality. One dragon produces enough hide for a single suit of masterwork hide armor for a creature one size category smaller than the dragon. By selecting only choice scales and bits of hide, an armorsmith can produce one suit of masterwork banded mail for a creature two sizes smaller, one suit of masterwork half-plate for a creature three sizes smaller, or one masterwork breastplate or suit of full plate for a creature four sizes smaller. In each case, enough hide is available to produce a small or large masterwork shield in addition to the armor, provided that the dragon is Large or larger.

Because dragonhide armor isn’t made of metal, druids can wear it without penalty.

Dragonhide armor costs double what masterwork armor of that type ordinarily costs, but it takes no longer to make than ordinary armor of that type.

Dragonhide has 10 hit points per inch of thickness and hardness 10.